Ultra Low Profile Wafer Head Laptop Screws

These screws feature a reliable TORX drive that facilitates more reliable installation and support smaller and lighter design.

With the miniaturisation of a large number of products, this has become an invaluable addition to the range of screws. With a flattened fastening face, this supports layers of parts.

The Hexalobular Torx drive provides a slip-less and easy fixing. Stainless Steel provides long life and corrosion resistance.

Applications:

-For flat surface design without head edge
-For smooth appearance design

In installation where the part does not permit deep enough holes to make a countersunk.

The large diameter heads of the low-profile screws have been engineered to spread the load across a wide surface to provide greater holding power in thinner material applications. These offer a sleek, unobtrusive and polished finish for any design.

Saves space and permits flexible design, especially in weight and space sensitive applications such as drones, electric scooters, aerospace and medical equipment.

JCSlim Low Profile Wafer Head Screws

Low profile or Wafer Head screws are often used in laptops and other electronic components.

Made from Steel with a Black Coating, this has many advantages.

• Magnetic to facilitate easy holding to the driver bit.
• Black coated to match with most electronic assemblies and light absorption.
• Low profile head for space and weight saving.
• Lengths as short as 2 mm for an M2 screw available.
• Lengths in decimals also available eg. 2.5, 3.5 etc

Available in Steel BLACK coated.
Sizes: M1.2 to M3

This finish is very useful in reducing light reflection from parts and providing an integrated finish to black coloured products and parts.

These screws have a permanent black colour with exceptional strength and elasticity that does not chip, peel, craze, or rub off and provides good resistance to wear and abrasion.

Applications:

• For flat surface design without head edge
• For smooth appearance design
• In installation where the part does not permit deep enough holes to make a countersunk.